4-Channel 3.3V–5V Bidirectional Logic Level Converter (2-Ch Ready)
4-Channel 3.3V–5V Bidirectional Logic Level Converter (2-Ch Ready)
Couldn't load pickup availability
Delivery Options
Delivery Options
- Local delivery within Hong Kong and in-store pickup.
- Free shipping for orders of HK$400 or above; HK$35 shipping fee for orders below HK$400.
- Shipped by SF Express, usually dispatched the same day for orders confirmed before 6:00 PM (Mon–Sat).
- Estimated delivery time: 1–3 business days after dispatch (Hong Kong).
- In-store pickup details (location and time) will be confirmed by email or phone message.
- Delivery times are estimates and may be affected by weather or unforeseen circumstances.
Bidirectional 3.3V–5V Translation for 4-Channel & 2-Channel Setups
This passive MOSFET level converter translates four digital signal channels simultaneously in both directions between a high-voltage system (HV1–HV4) and a low-voltage system (LV1–LV4). Each channel operates independently using its own MOSFET and 10kΩ pull-up resistors, so you can easily use just two channels for 2-wire I2C (SDA/SCL) or UART (TX/RX) communication and leave the remaining two channels unconnected without affecting operation. It works cleanly with both open-drain and push-pull buses, letting 3.3V boards such as ESP32, ESP8266, STM32, or Raspberry Pi interface safely with 5V Arduino Uno boards and 5V sensors.
Clean Pinout and Included Breadboard Headers
The blue PCB features clear silkscreen markings on both sides (Level Converter MH on the rear), separating the High-Voltage row (HV1, HV2, HV, GND, HV3, HV4) from the Low-Voltage row (LV1, LV2, LV, GND, LV3, LV4). Each board ships with two 6-pin 2.54mm straight male headers ready for soldering onto a standard solderless breadboard or perfboard. Note that because this 4-channel module has 6 pins per side (12 pins total), it requires jumper wires or a 12-pin layout rather than plugging directly into a narrow 4-pin-per-side 2-channel socket.
Technician Tip
Always remember that this is a signal level converter, not a DC power converter—it has no onboard 3.3V LDO regulator. Our technicians at Sun Cheong emphasize that you must connect your 5V reference supply to HV, your 3.3V reference supply to LV, and connect both grounds to GND for the MOSFETs to switch properly. When using only two channels (such as HV1/LV1 and HV2/LV2 for I2C), simply leave HV3/LV3 and HV4/LV4 unconnected.
